A cím elején, valamint az első képen szereplő szín/minta/méret/típus kerül kiszállításra!
 
600W Aluminum Plate DC-DC Boost Converter Adjustable 10A Step Up Constant Current Power Supply Module Led Driver for Arduino
 
Description
Module Type: Non-isolated booster module (BOOST)
Input Voltage: DC 10V-60V
Input Current: 10A (MAX)
Static Working Current: 10mA (The higher output voltage, the higher static current)
Output Voltage: 12-60V Continuing Adjust
Output Current: 10A MAX, Please enhance heat sink if exceed 6A (The larger voltage difference between input and output, the smaller output current)
Constant Current Range: 0.2-10A
Output Power: 600W (max), suggest to leave some slack for long time work
Working Temperature: -40 to 85 degree Celsius (Please enhance heat sink for over-temperature)
Operating Frequency: 150KHz
Conversion Efficiency: 92% -96% (Efficiency is related to input, output voltage, current and voltage difference)
Input Reverse Connection Protection: NO
Mounting Type: 4PCS 3mm screw hole
Connection Mode: Lead wire output
Module Size: 85x52x21mm(LxWxH)
 
Output voltage/current regulation method:
1. Adjust the CV-ADJ potentiometer to set the output voltage to the desired voltage according to your battery or LED.
2. Turn CC-ADJ potentiometer clockwise for about 30 turns, set the output current to the minimum, connect the LED, and turn CC-ADJ potentiometer to the current you need. If it is used for battery charging, after the battery is fully discharged, and then connected to the output, adjust CC-ADJ potentiometer to the current you need (the more residual battery power, the lower charging current).
 
Tip:
Please do not use short circuit to adjust the current, otherwise it will damage the module.
The module is a booster module, the input voltage should be 2V lower at least than the output voltage.
Input and output cannot be reversed.
The input voltage shall not be less than 10V or more than 60V.
 
Package Included
1 Pcs 600w Boost Constant Current Module
1005001660632862. - yikesu