A cím elején, valamint az első képen szereplő szín/minta/méret/típus kerül kiszállításra!
 
TB6612 DRV8833 Dual Motor Driver 1A TB6612FNG for Arduino Microcontroller Better Than L298N
 

 
Description
DRV8833:
DRV8833 Controller DC Motor PAP description
Driver DRV8833 can control up to two DC motors or one stepper motor with a constant current of 1.5 A (peak 4A ).
The motors are controlled, independently by means of PWM signals the direction of rotation of the motors can be controlled, neutral or stop with a frequency of up to 100 kHz.
Two input signals (IN1 and IN2) can be used to control one motor (connected to OUT1 and OUT2) and the other two input signals (IN3 and IN4) to control the second motor (connected to OUT3 and OUT4).
NOTE:
This DRV8833 dual-bridge motor controller is the replacement for the TB6612FNG dual-channel motor controller.
The pins come unsoldered.
If the motor draws currents above 0.6A, the use of a heat sink may be required.
DRV8833 Controller DC Motor PAP features:
- Driver chip: DRV8833
- Supply voltage: Vcc = 2.7-10.8V
- Output current: Iout = 1.5A (RMS per channel) / 4A peak
- Energy saving (sleep function). Div >
- Operating modes: Turn clockwise, anti-clockwise, neutral and brake.
Useful links for programming Arduino / Raspberry and projects with Arduino / Raspberry boards:
how to use DRV8833 with Arduino
datasheet Driver DRV8833
TB6612:
The TB6612FNG motor driver can control up to two DC motors at a constant current of 1.2A (3.2A peak). Two input signals (IN1 and IN2) can be used to control the motor in one of four function modes - CW, CCW, short-brake, and stop. The two motor outputs (A and B) can be separately controlled, the speed of each motor is controlled via a PWM input signal with a frequency up to 100kHz. The STBY pin should be pulled high to take the motor out of standby mode.
Logic supply voltage (VCC) can be in the range of 2.7-5.5VDC, while the motor supply (VM) is limited to a maximum voltage of 15VDC. The output current is rated up to 1.2A per channel (or up to 3.2A for a short, single pulse).
Board comes with all components installed as shown. Decoupling capacitors are included on both supply lines. All pins of the TB6612FNG are broken out to two 0.1" pitch headers; the pins are arranged such that input pins are on one side and output pins are on the other.
Power supply voltage: VM=15V max, VCC=2.7-5.5V
Output current: Iout=1.2A(average) / 3.2A (peak)
Standby control to save power
CW/CCW/short brake/stop motor control modes
Built-in thermal shutdown circuit and low voltage detecting circuit
All pins of the TB6612FNG broken out to 0.1" spaced pins
Filtering capacitors on both supply lines
Dimensions: 0.8x0.8"
 
Package Included
1 Pcs Dual Motor Driver
1005004022712675./2 - yikesu