A cím elején, valamint az első képen szereplő szín/minta/méret/típus kerül kiszállításra!
 
WX-101 Temperature Control Board Temperature Control Switch Digital Thermostat High - Precision Micro - Thermostat DC 12V
Description:
1. Contact capacity: AC220V 12A
2. Electrical life: 1000000 times
3. Mechanical life: 1000000 times
4. Power supply: DC12V / DC5V
5, the working environment: -20 ~ 85 degrees, relative humidity less than or equal to 85% , no corrosive and no strong electromagnetic radiation occasions.
Instructions:
① factory settings: press and hold the set button to power, 3 seconds after the release button to restore the factory settings!
(2) Control mode setting: Press the 'SET' button once to display F-1, then press the 'SET' button again to enter the F-1 menu, then press the 'plus' button to display 【HH】 for heating control mode, 'Button display [CC] for the cooling control mode, select a good press the set button to save the exit!
③ temperature setting: in the display of the current temperature interface directly press the 'plus' or 'minus' button can set the required control temperature point, set the time after the 'set' button to save and exit!
④ Press the 'Add' button to adjust the function number. When the F-1 is displayed, press the 'plus' button to display the F (1) key. -2, then press the 'set' button once to enter the F-2 function, that is, the hysteresis parameter adjustment interface, directly press the 'plus' or 'minus' button to adjust the hysteresis, hysteresis means start temperature and stop The temperature difference, if you want to control the heating If the control temperature set 30 degrees, hysteresis set to 2, then the current temperature is more than 30 degrees relay disconnect, less than 28 degrees relay closed, the hysteresis is 2! Refrigeration control is the opposite control state!
⑤ temperature correction settings: adjust the function number for the F-3 display, press the 'set' button to enter the F-3 parameter adjustment interface, adjust the range of -5.0 ~ 5.0, when the temperature is not accurate, this function can be temperature correction , If the measured current temperature is higher than the actual temperature of 0.5 degrees, adjust the calibration parameter is -0.5, press the 'set key' to save!
⑥ delay start time setting: when the start after the start to the next start to meet the set time before they can start, usually for the cooling control mode to protect the compressor, the heating control can be set to 0, the factory default is 0, Delay time 0-10 minutes
Quick setup method
1: Set mode
2: Set the temperature
3: hysteresis
Shipping list:
1 Pcs WX-101 Module
32832335850. - yikesu