A cím elején szereplő szín/minta/méret/típus kerül kiszállításra!
TP4056 5V Micro 1A Lithium Battery Charging Board Module Charger
Description:Specification:Brand new and high quality.
Module features and parameters:Input with a MICRO USB female, you can directly use the phone charger to do input to the lithium battery charging, and still retain the input voltage wiring pads, can be very convenient DIY
Input voltage: 5V
Charging cut-off voltage: 4.2V ± 1%
Maximum charge current: 1000mA
Battery over discharge protection voltage: 2.5V
Battery overcurrent protection current: 3A
Board size: 2.6 * 1.7CM
Instructions:Note: one access to the battery, there may be no voltage between OUT and OUT- output, then access to 5V voltage charge can be activated on the protection circuit, the battery from the B B- on the short open then then need to charge Take electricity to activate the protection circuit. When using the phone charger to make the input Note that the charger must be able to output 1A or more, or may not be able to properly charge
MICRO USB master and its next - pad for the power input, access 5V voltage. B then the lithium battery positive, B - then the negative lithium battery. OUT and OUT- connected load, such as the mobile booster positive or negative load or other load.
Then the battery to B B-, insert the phone charger to the USB female, red light is charging, green light is full.
Can be used for voltage 3.6 3.7V and so on 18650, polymer and other lithium battery charge and discharge protection, single or multiple parallel can also be used.
Packing List:1x pcs
SPU:TPO6383
Preview:
402631720741 - urukz (37)