Nagy kapacitású láng bután gáz forrasztópáka készlet toll láng fáklya barkács szerszám hegy használata Bután gáz forrasztópáka toll HT-1937
High Capacity Flame Butane Gas Soldering Iron Kit Set Pen Flame Torch DIY Tool Tip use Butane Gas Soldering Iron Pen HT-1937
Pen-type gas 3-in-1 gas soldering iron HT-1937 with a torch head with a portable head
Name: pen type gas soldering iron
Model: HT-1937
Filling capacity: 12ML
Temperature: flame temperature of 1300 degrees, iron temperature of 450 degrees
Material: plastic metal
 
Instructions for use
First, fill the gas
1, use high-quality gas filling, and confirm the switch off at the OFF, and then add.
2, the gas tank into the pores, under pressure inflatable.
3, about 10 seconds to complete the filling of gas, wait a few minutes, so that gas stability, and then use.
4, if the gas poured into the tail after the hissing sound, with a pen tip slightly into the air, you can eliminate.
Second, the ignition
1, put on the tip
2, push the switch to the ON place, hear the "hissing" sound.
3, with a lighter or lighter, near the joints of the ignition.
4, the ignition after burning 3 minutes, to be extinguished, the tip will continue to heat.
5, adjust the flame size, to the "ten" direction, to "a" direction of small.
6, this product temperature up to 1300 degrees (iron temperature 450 degrees), the use of attention should be paid to safety, run off after the switch off to the OFF position.
7, the use of gas soldering iron, please pay special attention to wait until the flame completely eliminated, iron objects inside the red, and then operation, the flame size is not large, to extend the life of the tip.
8, the flame length of about 1.2-2.2 cm.
Third, note:
1, replace the connector, please wait after cooling or replacement or change in advance.
2, the use of the tip, high temperature and hot, do not touch by hand.
3, adjust the button to control the gas out of gas and temperature, usually placed in the middle position.
4, after use to be cooled, and then line collection, do not place at high temperature or direct sunlight.
5, children should not be used, the collection must be properly placed.
6, please use high-quality canned gas filling, filling away from the fire source.
7, because the gas or more may have some slag, often clean the nozzle is necessary.
8, when cleaning, the nozzle in the gas tank outlet on the jet can reach the cleaning effect.
9, to avoid heavy fall.
10, in any case do not try to disassemble or repair.
1005003765745277 - mark