- -40%
1db PCM5102 modul DAC dekóder I2S lejátszó az ES9023-on kívül összeszerelt PCM1794 tábla, alkalmas Raspberry Pi Hothoz
1db PCM5102 modul DAC dekóder I2S lejátszó az ES9023-on kívül összeszerelt PCM1794 tábla, alkalmas Raspberry Pi Hothoz
1 348 Ft
40% megtakarítás
2 247 Ft
Nincs adó
New PCM5102 DAC Decoder I2S Player Beyond ES9023 Assembled Board PCM1794 Suitable For Raspberry Pi Hot
Support I2S/left-justified signel directly input (can switch by hand)
The maximum support 32 Bit 384K Sampling rate.
Can setting two FLT filter mode (NOM normal mode or LOW Delay mode)-Need switch by hand.
SNR: 112db. Distortion: -93db
Directly output is 2.1V RMS audio voltage ,High frequency is pure ,Low frequency is satiation ,Beyond ES9023
PCB size: Approx. 5x5.5x2cm / 1.97x2.17x0.79 inch
Power supply voltage: DC 5-10V (VCC to 5-10V, GND to GND)
color: yellow
Material: PCB
Package Contents:
1 x PCM5102 Module
Note:
Do not connect the power supply reversely, or the board will be damaged.
The voltage over 10V will damage the board.
VCC and GND need to be connected with power supply,and the remaining GND LRCK DATA BCK should be connected with I2S signal input. (This board does not need to connect to the MCLK chip, PLL internal frequency rise, MCLK clock, much better than using asynchronous clock. The internal PLL rise frequency is only used to generate the internal MCLK clock and can not raise the audio sampling rate.)
Only the above package content, other products are not included.
Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is /- 1-3cm.
Support I2S/left-justified signel directly input (can switch by hand)
The maximum support 32 Bit 384K Sampling rate.
Can setting two FLT filter mode (NOM normal mode or LOW Delay mode)-Need switch by hand.
SNR: 112db. Distortion: -93db
Directly output is 2.1V RMS audio voltage ,High frequency is pure ,Low frequency is satiation ,Beyond ES9023
PCB size: Approx. 5x5.5x2cm / 1.97x2.17x0.79 inch
Power supply voltage: DC 5-10V (VCC to 5-10V, GND to GND)
color: yellow
Material: PCB
Package Contents:
1 x PCM5102 Module
Note:
Do not connect the power supply reversely, or the board will be damaged.
The voltage over 10V will damage the board.
VCC and GND need to be connected with power supply,and the remaining GND LRCK DATA BCK should be connected with I2S signal input. (This board does not need to connect to the MCLK chip, PLL internal frequency rise, MCLK clock, much better than using asynchronous clock. The internal PLL rise frequency is only used to generate the internal MCLK clock and can not raise the audio sampling rate.)
Only the above package content, other products are not included.
Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is /- 1-3cm.
Biztonsági feltételek
Szállításii feltételek
Visszaküldési feltételek
