1 készlet L298N motorvezérlő kártya léptetőmotor vezérlő modul, kettős H-híd 4 készlet egyenáramú motor intelligens autó kerék Arduinohoz
1Set L298N Motor Controller Board Stepper Motor Control Module Dual H-Bridge 4 Sets DC Motor Smart Car Wheel For Arduino
DC Motor
Operating Voltage: 3V ~ 6V DC
Reduction ratio: 1:48
When the voltage is 6V:
No-load current: ≤200mA
No-load speed: 200±10% rpm
 
When the voltage 3V:
No-load current: ≤150mA
No-load speed: 90±10% rpm
Used for electronic fans, electronic machinery, toys, cars, robots, arduino projects, etc.
L298N Motor Drive Controller Board 
Module name : dual H bridge motor drive module
Work mode : H bridge drive (double road)
Main control chip : ST L298N dual H-bridge driver chip
Logical voltage : 5V
Drive voltage : 5v-35v
Logical current : 0mA-36mA
Driving current : 2A(MAX single bridge)
Storage temperature : - 20 ℃ to 135 ℃
Maximum power : 25W
Notes:
General Application: When your driver is 7V-12V, you can enable the on-board 5V logic supply.
When using the on-board 5V power supply, the 5V power supply in the interface does not input voltage, but it can draw 5V voltage for external use.
Unconventional application of high-voltage drive: When the driving voltage is higher than 12V, less than or equal to 24V, for example, to drive a motor with rated voltage of 18V, the jumper cap with 5V output enabled on-board voltage must be pulled out and then outside the 5V output port Connect 5V voltage to L298N internal logic voltage supply.
Product List:
4 x Smart Car Wheel
4 x DC Motor
2 x L298N Motor Drive Controller Board
20 x 20CM Jumer Wire female to female
20 x 20CM Jumer Wire Male to Male
20 x 20CM Jumer Wire Male to Female
1005003140454443 - modules