- -43%
2SA1295 2SC3264 - HiFi MX50 SE KEC SANKEN 2.0 kétcsatornás 2x 100W sztereó végerősítő barkácskészlet és kész kártya
2SA1295 2SC3264 - HiFi MX50 SE KEC SANKEN 2.0 kétcsatornás 2x 100W sztereó végerősítő barkácskészlet és kész kártya
1 100 Ft
43% megtakarítás
1 930 Ft
Nincs adó
Lower distortion, better control and resolution. Single differential input, single-ended voltage amplifier stage, three-stage inverting Darlington output stage.
The small tube is produced by PHILIPS, and the output stage is imported KTB817, KTD1047.
ST, EVOX produces CBB capacitors.
KEMET, TDK's monolithic capacitors.
Electrolytic capacitors imported from Japan
All resistors use original authentic metal film resistor copper feet.
Supported voltage DC: -15V to -45V
AC dual 12V- dual 32V can be obtained after rectification.
Power 15-100W, 8 ohms.
PCB area 76*73 mm Version number V7(MX50SE)
Installation Note: The 649 669 must be installed on the mating radiator.
No adjustment is required after installation, and the quiescent current is about 30MA per tube. This version does not require flying leads. Just attach the two large tubes to the radiator.
The MX50 L series AMPs designed by me have been tested by a variety of instruments and have excellent performance. The components and PCB versions used in the imitation MX50 or music fax XX50 circulating on the Internet are different, please pay attention to the comparison if you buy. The current version of MX50 is V7 ( MX50SE )
Test data: Test equipment: Audio Precision 2
Frequency response=20HZ-25K HZ-0.2DB
The small tube is produced by PHILIPS, and the output stage is imported KTB817, KTD1047.
ST, EVOX produces CBB capacitors.
KEMET, TDK's monolithic capacitors.
Electrolytic capacitors imported from Japan
All resistors use original authentic metal film resistor copper feet.
Supported voltage DC: -15V to -45V
AC dual 12V- dual 32V can be obtained after rectification.
Power 15-100W, 8 ohms.
PCB area 76*73 mm Version number V7(MX50SE)
Installation Note: The 649 669 must be installed on the mating radiator.
No adjustment is required after installation, and the quiescent current is about 30MA per tube. This version does not require flying leads. Just attach the two large tubes to the radiator.
The MX50 L series AMPs designed by me have been tested by a variety of instruments and have excellent performance. The components and PCB versions used in the imitation MX50 or music fax XX50 circulating on the Internet are different, please pay attention to the comparison if you buy. The current version of MX50 is V7 ( MX50SE )
Test data: Test equipment: Audio Precision 2
Frequency response=20HZ-25K HZ-0.2DB
Biztonsági feltételek
Szállításii feltételek
Visszaküldési feltételek
