GY-362 ADXL362 3 tengelyes digitális gravitációs érzékelő gyorsulási modul alternatív ADXL345 modul I2C SPI IIC interfész
GY-362 ADXL362 3-Axis Digital Gravity Sensor Acceleration Module Alternative ADXL345 Module I2C SPI IIC Interface
Overview
The ADXL362 is an ultra-low power, 3-axis MEMS accelerometer that outputs data
Power consumption is less than 2 μA at 100 Hz and in motion-triggered wake-up mode
is 270 nA. Unlike accelerometers that use periodic sampling to achieve low power consumption,
The ADXL362 does not alias the input signal by undersampling; it uses the full data rate
rate to sample the entire bandwidth of the sensor.
The ADXL362 typically provides 12-bit output resolution; adequate at lower resolutions
8-bit data output is also provided for more efficient single-byte transfers. Measurement
The volume range is ±2 g, ±4 g and ±8 g, and the resolution in the ±2 g range is 1 mg/LSB.
Applications that require a noise level lower than the ADXL362's normal 550 μg/√Hz can choose
select one of two low noise modes (as low as 175 μg/√Hz typical), supply current
The increase is very small.
In addition to ultra-low power consumption, the ADXL362 has many features to enable true
system-level energy savings. The device contains a deep multimode output FIFO,
A built-in micropower temperature sensor and several motion detection modes, including
Including sleep and wake-up working mode with adjustable threshold, in this mode, when measuring speed
Power consumption is as low as 270 nA at a rate of around 6 Hz. If required, it can be detected
Provides a pin out to directly control an external switch during motion. also,
The ADXL362 also supports external control of the sample time and/or system clock.
The ADXL362 operates over a wide supply voltage range of 1.6V to 3.5V, and
And if necessary, it can interface with a host computer operating with an independent low power supply voltage.
1005004116562280 - blackh