- -43%
2wd rc wifi okos autós készlet L293D by ESP-12E esp8266 esp 12e diy rc játék távirányító telefonon Lua nodeMCU
2wd rc wifi okos autós készlet L293D by ESP-12E esp8266 esp 12e diy rc játék távirányító telefonon Lua nodeMCU
1 569 Ft
43% megtakarítás
2 753 Ft
Nincs adó
WiFi RC Smart Car based on ESP-12E
Introduction
Really? so cheap for a WiFi RC smart car? Yes. You are right.
This WiFi RC smart car is designed and developed based on ESP-12E from ESP8266, which can be controlled by mobile, PC, and wechat (now just in China). All of thedocuments can be downloaded for the DOIT official site: www.doit.am, including the scheme for car.
After get it, can further develop based on the Lua IDE.
ESP-12E motro shield
Feature
l Name: ESP-12E motor shield
l using ESP-12 DEV KIT development shieldmodule
l extend the output ports for ESP-12 DEVKIT: SPI, UART, GPIO, AI and 3.3V power interface
l extend 2-ways motor, then can directlydrive 2-ways motor
l design a power switch
l voltage for motor: 4.5V-36V
l voltage for ESP control board: 4.5V-9V
l disparate the power of ESP board andmotor for avoiding the interference. In our experiments, for convenience, a shortcut module is used to connect VIN and VM for the power of ESP board andmotor.
l driven cihip: L293D
NodeMCU
More details forNodeMCU, can be found at www.nodemcu.comand https://github.com/nodemcu/nodemcu-firmware/wiki/nodemcu_api_en
Shipping List
l ESP-12Emotor shield: 1pcs
l NodeMCUdevelopment board: 1pcs
l Carchassis kit: 1set
Introduction
Really? so cheap for a WiFi RC smart car? Yes. You are right.
This WiFi RC smart car is designed and developed based on ESP-12E from ESP8266, which can be controlled by mobile, PC, and wechat (now just in China). All of thedocuments can be downloaded for the DOIT official site: www.doit.am, including the scheme for car.
After get it, can further develop based on the Lua IDE.
ESP-12E motro shield
Feature
l Name: ESP-12E motor shield
l using ESP-12 DEV KIT development shieldmodule
l extend the output ports for ESP-12 DEVKIT: SPI, UART, GPIO, AI and 3.3V power interface
l extend 2-ways motor, then can directlydrive 2-ways motor
l design a power switch
l voltage for motor: 4.5V-36V
l voltage for ESP control board: 4.5V-9V
l disparate the power of ESP board andmotor for avoiding the interference. In our experiments, for convenience, a shortcut module is used to connect VIN and VM for the power of ESP board andmotor.
l driven cihip: L293D
NodeMCU
More details forNodeMCU, can be found at www.nodemcu.comand https://github.com/nodemcu/nodemcu-firmware/wiki/nodemcu_api_en
Shipping List
l ESP-12Emotor shield: 1pcs
l NodeMCUdevelopment board: 1pcs
l Carchassis kit: 1set
Biztonsági feltételek
Szállításii feltételek
Visszaküldési feltételek
