- -40%
DC10-60V DC 10-60V motor fordulatszám szabályozás PWM motor fordulatszám vezérlő kapcsoló 20A áramfeszültség
DC10-60V DC 10-60V motor fordulatszám szabályozás PWM motor fordulatszám vezérlő kapcsoló 20A áramfeszültség
343 Ft
40% megtakarítás
571 Ft
Nincs adó
Technical indicators
Input voltage: DC10-60V Output voltage: linear under load
Output limit current: 20A (use 10A for a long time, within 450W, pay attention to keep the module unobstructed heat dissipation conditions)
Limit power: 1200W
Speed regulation type: current regulation speed regulation mode: potentiometer (linear)
Speed control duty ratio range: 0 -- control frequency: 25KHZ
Wiring type: fence type wiring terminal knob Wire length: 20CM
Module size: length * width * height 77MM*45MM*28MM Product net: 73 grams
According to the installation size of the motherboard: length * width 73MM*40MM potentiometer according to the installation hole: 7MM
The wiring diagram
Make sure the positive and negative connections are correct before powering on, and do not touch the heat sink, which may burn the circuit board. Note that this is not a power module, you must be connected to the motor to speed, without the motor multimeter output does not change.
The input is 9-60V internal DC
POWER supply: the POWER POWRE -
MOTOR: the MOTOR MOTOR
Please note:
1. This type of governor is used for dc brush motor.
2. Not suitable for speed regulation of brushless DC motor; Can not be used as a voltage regulator or regulator!
Input voltage: DC10-60V Output voltage: linear under load
Output limit current: 20A (use 10A for a long time, within 450W, pay attention to keep the module unobstructed heat dissipation conditions)
Limit power: 1200W
Speed regulation type: current regulation speed regulation mode: potentiometer (linear)
Speed control duty ratio range: 0 -- control frequency: 25KHZ
Wiring type: fence type wiring terminal knob Wire length: 20CM
Module size: length * width * height 77MM*45MM*28MM Product net: 73 grams
According to the installation size of the motherboard: length * width 73MM*40MM potentiometer according to the installation hole: 7MM
The wiring diagram
Make sure the positive and negative connections are correct before powering on, and do not touch the heat sink, which may burn the circuit board. Note that this is not a power module, you must be connected to the motor to speed, without the motor multimeter output does not change.
The input is 9-60V internal DC
POWER supply: the POWER POWRE -
MOTOR: the MOTOR MOTOR
Please note:
1. This type of governor is used for dc brush motor.
2. Not suitable for speed regulation of brushless DC motor; Can not be used as a voltage regulator or regulator!
Biztonsági feltételek
Szállításii feltételek
Visszaküldési feltételek
