A cím elején, valamint az első képen szereplő szín/minta/méret/típus kerül kiszállításra!
New 500KV 500000V Boost Step Up High-Voltage Generator Ignition Coil Pulse Power Module Igniter DC 6V-12V High Voltage Generator
Description:
input voltage: DC 3 V to 6 V Input current: 2 A - 5 A High pressure type: the
type of pulse current Output voltage: 400000 v(Please pay attention to safety)
High pressure discharge distance between: 10 mm - 20 mm The output high voltage
wire length: 100 mm Input power cord length: 100 mm (the red line is positive)
Wiring: Red and green power connection red line:" " green line "-" output : the
other side ,same color cable please notice: the high-voltage module should avoid
the use of electricity in high voltage no-load . (Power must be adjusted to a
suitable distance to the high-voltage output line , battery capacity is
proportional to the distance and the use of the high-pressure arc ( not a
voltage as high as possible , you must provide enough current ) . Experimental
test of the arc distance from short to long , Do not exceed the maximum arc
distance electricity, energy can not be released due to high pressure , can
easily damage the module. ) Work: intermittent , continuous work does not allow
more than 1 minute and the output side does not allow shorting . Improper
voltage and long working hours easily damaged module Package included: 1 x DC
3v-6v to 400kV 400000V Boost Step-up Power Module High-voltage Generator
Description:
DC12V DC high voltage pulse generator module ignition coil capacitance arc distance 50mm
12V input, good power, quality, arcing distance, sound shocking, simple operation
Specifications:
Peripheral circuit is simple (just plug in switches, batteries can be) the discharge intensity violent.
Module Model: MCY-12-1
Physical volume: Length 70X 32mm diameter
Input voltage: 6V-12V
Input Current: 0.5A-1A
Input line length: 23 cm
High voltage type: DC type pulse
Output voltage: about 500KV (please pay attention to safety when used)
Output Current: 0.5A-1A
Output line length: about 92 cm
High voltage bipolar discharge distance: 2 cm -5 cm
Features:
This module is a science of small production with high voltage inverter transformer / booster finished module
After the input terminal DC6V-12V voltage can get tens of thousands of volts of direct current high voltage at the output,It can be used for high school science experiment, electronic equipment, negative ion generator, high voltage source when using scientific small production,Module uses the Tesla coil principle is made,
the output high voltage pulse current, small size, high efficiency
Usage:
1. To avoid the use of electricity at high voltage load, must adjust the proper distance
between the front end of the high-voltage power-
2. To test the arc distance from short to long experiment, when power is strictly prohibited exceed
the maximum arcing distance, energy can not be released due to high pressure, easy to damage the module.
3. Power module, the internal should not heat, so we can not work long hours.
4. Determine whether the battery capacity can drive maximum power output of the battery
voltage measurement approach is arcing time. If 6V or so you can output the maximum power.
5. Two small-capacity lithium series is 7.2V, measured in arc-state voltage has dropped to about 4V,
the capacity of the smaller voltage pull lower. It is proposed to use lithium 2000MA above,
the best conditions with more battery 4000MA.
Package includes:
1x DC12V pulse high-voltage module
1005001342578212 - greatit