JDiag EL-50448 TPMS Reset eszköz a GM Opel TPMS aktiválásához le tudja olvasni a gumiabroncs-nyomás érzékelőt az összes

JDiag EL-50448 TPMS Reset Tool for GM Opel TPMS Activation Can Read The Tire Pressure Sensor Works on All General Motors
JDiag EL-50448 TPMS Activation Tool
ATTENTION:If there is any destination tax/duties for the package, that is afforded by buyer. But we will mark a declared low value to minimize buyer's custom tax  if you need. Thanks very much for your understanding!
JDiag EL-50448 TPMS Reset Tool is original item from JDiag Company, quality is good, JDiag EL-50448 TPMS Reset Tool is the specified diagnostic tools which can read the tire pressure sensor for models in & after 2012.
Before tire pressure monitoring system works normally properly, the body control module will record ID information of each position in the tire pressure sensor; and use the following methods to read the tire pressure sensor after replacing a tire or wheel speed sensor.
Diag EL-50448 TPMS Reset Tool works on all General Motors (For B-uick, for C-adillac, for C-hevrolet, for G-MC) products manufactured for the North American market. It won't work if you've purchased aftermarket sensors that are the wrong frequency. EL50448 fit for G.M most kind of vehicles, equipped with a 315 or 433 MHz Tire Pressure Monitoring (TPM) system. This re-learn procedure can be performed by using special tool EL-50448.
Please refer to the specific methods as follows for this EL-50448 TPMS Activation Tool:
Step 1 - Enter leaning mode
Set the gearshift lever to "P"
Put the ignition switch to "ON"
Enter the interface of tire pressure display by DIC
DIC shows "Press Set / Ctrl to re-learn"
Press "Set / Ctrl"
The turn signal is lighted for 3 seconds and the horn beep sound twice to enter the learning mode
Step 2 - Read tire pressure sensor information
Start from the front-left wheel,
Make the J-46079 or EL-50448 TPMS Activation Tool antenna up against the valve core position & close to the rim of the tire sidewall
EL-50448 TPMS Activation Tool starts by the start switch
Successful to read the tire pressure sensor information when the horn bleeps once
Step 3 - Same method to read other tire pressure information
Follow the instuction above to read tire pussure of the front-right, rear-right, rear-left wheels.
Turn signals is lighted for 3 seconds and the horn bleeps twice when the learning is complete.
Package include:
1pc * JDiag EL-50448 TPMS Activation Tool
Notice:The package does not include the charger and battery,please buy themby yourself.