• -43%

4S 14,8V 12A Li-ion lítium akkumulátor 18650 töltővédő kártya 16,8V

4S 14,8V 12A Li-ion lítium akkumulátor 18650 töltővédő kártya 16,8V

142 Ft 43% megtakarítás
249 Ft
Nincs adó
Note:
      The protective plate can not be used for lithium iron phosphate battery, hernia lamp, hand drill battery pack, electric fish battery, electric bicycle battery pack, buggy battery, 775 (4A) above motor, 1W fish eye LED lamp, Please pay attention to the combined purchase of customers! .
 
The product is suitable for the following products:
     Power Inverter, Massager Battery Pack, LED Lamp Standby Power Supply, Electronics, Solar Street Light Battery Pack, Monitoring Standby Power Supply, and more.
 
Note: 3A current discharge products, battery discharge rate to 3C above.
Rate calculation formula: 1C rate of battery, 2000 capacity is equal to 2AH * 1 = 2A maximum operating current.
 
3C rate of battery, 2000 capacity is equal to 2AH * 3 = 6A maximum operating current.
In use, the battery will heat is not applicable to battery magnification, this situation can not be long-term use, the battery will soon be damaged.
 
Note:
1: Strictly according to the diagram wiring 0V (B -), 3.7V (B1), 7.4V (B2), 11.1V (B3), 14.8V (B ), do not short!
 
2: Need to charge after connecting the line, will have output.
 
3: 4 batteries in series, please ensure that each battery voltage is the same, if not the same, please fill each battery separately and then use in series. During the discharge test, the battery whose voltage dropped quickly was a bad battery.
 
Tip: Do not mix good batteries with bad batteries! The capacity / internal resistance of the 4 batteries is as close as possible! (2 good batteries 2 bad batteries = 4 bad batteries).
 
Lithium battery protection board parameters:
 
Model: Long HX-4S-A01 / Short HX-4S-A10
 
Long section size: 72 * 17 * 3.0mm
 
Short paragraph size: 65 * 17 * 3.0mm
 
 Overcharge voltage range: 4.25-4.35v ± 0
 
Over discharge voltage range: 2.3-3.0v ± 0.05v
 
Upper limit working current: 6-8A
 
Upper limit instantaneous current: 12A
 
Quiescent current: less than 30uA
 
Internal resistance: less than 100mΩ
 
Charging voltage: 16.8V-17V
 
Operating temperature: -40 --- 50 ℃
 
Storage conditions: -40-- 80 ℃
 
 Effective life: more than 50,000 hours
 
Short circuit protection: can be protected, need to restore the charge
 
Protection board components: Components for the S-8254AA protection chip and AO4407 * 4.
Mennyiség

 

Biztonsági feltételek

 

Szállításii feltételek

 

Visszaküldési feltételek

4S 14,8V 12A Li-ion lítium akkumulátor 18650 töltővédő kártya 16,8V
4S 14.8V 12A Li-ion Lithium Battery 18650 Charger Protection Board 16.8V
Note:
      The protective plate can not be used for lithium iron phosphate battery, hernia lamp, hand drill battery pack, electric fish battery, electric bicycle battery pack, buggy battery, 775 (4A) above motor, 1W fish eye LED lamp, Please pay attention to the combined purchase of customers! .
 
The product is suitable for the following products:
     Power Inverter, Massager Battery Pack, LED Lamp Standby Power Supply, Electronics, Solar Street Light Battery Pack, Monitoring Standby Power Supply, and more.
 
Note: 3A current discharge products, battery discharge rate to 3C above.
Rate calculation formula: 1C rate of battery, 2000 capacity is equal to 2AH * 1 = 2A maximum operating current.
 
3C rate of battery, 2000 capacity is equal to 2AH * 3 = 6A maximum operating current.
In use, the battery will heat is not applicable to battery magnification, this situation can not be long-term use, the battery will soon be damaged.
 
Note:
1: Strictly according to the diagram wiring 0V (B -), 3.7V (B1), 7.4V (B2), 11.1V (B3), 14.8V (B ), do not short!
 
2: Need to charge after connecting the line, will have output.
 
3: 4 batteries in series, please ensure that each battery voltage is the same, if not the same, please fill each battery separately and then use in series. During the discharge test, the battery whose voltage dropped quickly was a bad battery.
 
Tip: Do not mix good batteries with bad batteries! The capacity / internal resistance of the 4 batteries is as close as possible! (2 good batteries 2 bad batteries = 4 bad batteries).
 
Lithium battery protection board parameters:
 
Model: Long HX-4S-A01 / Short HX-4S-A10
 
Long section size: 72 * 17 * 3.0mm
 
Short paragraph size: 65 * 17 * 3.0mm
 
 Overcharge voltage range: 4.25-4.35v ± 0
 
Over discharge voltage range: 2.3-3.0v ± 0.05v
 
Upper limit working current: 6-8A
 
Upper limit instantaneous current: 12A
 
Quiescent current: less than 30uA
 
Internal resistance: less than 100mΩ
 
Charging voltage: 16.8V-17V
 
Operating temperature: -40 --- 50 ℃
 
Storage conditions: -40-- 80 ℃
 
 Effective life: more than 50,000 hours
 
Short circuit protection: can be protected, need to restore the charge
 
Protection board components: Components for the S-8254AA protection chip and AO4407 * 4.
1005002688763719 - sitai
1005002688763719

Hasonló kategóriák mint 16 :

Reviews

Write your review

4S 14,8V 12A Li-ion lítium akkumulátor 18650 töltővédő kártya 16,8V

Note:
      The protective plate can not be used for lithium iron phosphate battery, hernia lamp, hand drill battery pack, electric fish battery, electric bicycle battery pack, buggy battery, 775 (4A) above motor, 1W fish eye LED lamp, Please pay attention to the combined purchase of customers! .
 
The product is suitable for the following products:
     Power Inverter, Massager Battery Pack, LED Lamp Standby Power Supply, Electronics, Solar Street Light Battery Pack, Monitoring Standby Power Supply, and more.
 
Note: 3A current discharge products, battery discharge rate to 3C above.
Rate calculation formula: 1C rate of battery, 2000 capacity is equal to 2AH * 1 = 2A maximum operating current.
 
3C rate of battery, 2000 capacity is equal to 2AH * 3 = 6A maximum operating current.
In use, the battery will heat is not applicable to battery magnification, this situation can not be long-term use, the battery will soon be damaged.
 
Note:
1: Strictly according to the diagram wiring 0V (B -), 3.7V (B1), 7.4V (B2), 11.1V (B3), 14.8V (B ), do not short!
 
2: Need to charge after connecting the line, will have output.
 
3: 4 batteries in series, please ensure that each battery voltage is the same, if not the same, please fill each battery separately and then use in series. During the discharge test, the battery whose voltage dropped quickly was a bad battery.
 
Tip: Do not mix good batteries with bad batteries! The capacity / internal resistance of the 4 batteries is as close as possible! (2 good batteries 2 bad batteries = 4 bad batteries).
 
Lithium battery protection board parameters:
 
Model: Long HX-4S-A01 / Short HX-4S-A10
 
Long section size: 72 * 17 * 3.0mm
 
Short paragraph size: 65 * 17 * 3.0mm
 
 Overcharge voltage range: 4.25-4.35v ± 0
 
Over discharge voltage range: 2.3-3.0v ± 0.05v
 
Upper limit working current: 6-8A
 
Upper limit instantaneous current: 12A
 
Quiescent current: less than 30uA
 
Internal resistance: less than 100mΩ
 
Charging voltage: 16.8V-17V
 
Operating temperature: -40 --- 50 ℃
 
Storage conditions: -40-- 80 ℃
 
 Effective life: more than 50,000 hours
 
Short circuit protection: can be protected, need to restore the charge
 
Protection board components: Components for the S-8254AA protection chip and AO4407 * 4.

Write your review