AD billentyűzet szimulálja az ötbillentyűs modul gombját az Arduino érzékelő bővítőkártyájához
AD Keyboard Simulate Five Key Module Button for Arduino Sensor Expansion Board
Warm prompt: Dear buyer, Our cheapest transportation services Economic category logistics (SunYou Economic Air Mail ,China Post Ordinary Small Packet Plus ) can be traced only befor it arrive your country,please choose Standard category logistics if you want a full tracking info.
 
 
Use an analog port to read the five key states for save IO port. With sensor expansion board can be completed and buttons of interactive works.
for Aruino test code:
/ / ADKeyboard Module
int adc_key_val [5] = {50, 200, 400, 600, 800};
int NUM_KEYS = 5;
int adc_key_in;
int key = -1;
int oldkey = -1;
void setup ()
{
pinMode (13, OUTPUT); / / we\'ll use the debug LED to output a heartbeat
Serial.begin (9600); / / 9600 bps
}
void loop ()
{
adc_key_in = analogRead (0); / / read the value from the sensor
digitalWrite (13, LOW);
key = get_key (adc_key_in); / / convert into key press
 
if (key! = oldkey) / / if keypress is detected
{
delay (50); / / wait for debounce time
adc_key_in = analogRead (0); / / read the value from the sensor
key = get_key (adc_key_in); / / convert into key press
if (key! = oldkey)
{
oldkey = key;
if (key> = 0) {
digitalWrite (13, HIGH);
switch (key)
{
case 0: Serial.println ("S1 OK");
break;
case 1: Serial.println ("S2 OK");
break;
case 2: Serial.println ("S3 OK");
break;
case 3: Serial.println ("S4 OK");
break;
case 4: Serial.println ("S5 OK");
break;
}
}
}
}
delay (100);
}
/ / Convert ADC value to key number
int get_key (unsigned int input)
{
int k;
 
for (k = 0; k
{
if (input
{
return k;
}
}
 
if (k> = NUM_KEYS) k = -1; / / No valid key pressed
return k;
}
 
1005003588163194 - a a