DC 12V 433M RF vezeték nélküli vevő Tanulási kód Relé EV1527 PT2262 ASK OOK Távirányító

Matching Keyfob:  Click here
 
 
Typical applications:
DC 12V Home lighting system 
Remote control switch
Smart Home / Home Automation
LED lighting
Fluorescent lamp
DC 12 DC Motor,RS360
 
 
Wiring Diagram 1:
 
 
 
 
Wiring Diagram 2:
 
  
Product Name : DC 12V 433M RF Wireless Receiver Learning code Relay for EV1527 PT2262 ASK OOK Remote control
 
Packing list:
1 PCS DC 12V 433M RF Wireless Receiver Learning code Relay

 
 
Technical indicators:
operating voltage : DC 12V;
Operating frequency : 433.92MHz ;
Receiver sensitivity :-95dB;
Encoding: Receiver Recording;
Momentary / Latch / Toggle selectable (defult is  Momentary  , Latch Mode need 2 buttons handsender );
Learning function (can works with EV1527 and PT2262 remote(Click here), can store 16 pcs different code remote );
PCB Size:41×20×15mm;
Max load : 500W;
 
Advantage :
1: Receiver Mother board have a learning key , if the remote is lost , must buy EV1527 OR Pt2262 remotes to re-learn;
 
Relay mode :
Normally close (NC ) ;
Normally open (NO ) ;
Normally-open (NO) contacts connect the circuit when the relay is activated; the circuit is disconnected when the relay is inactive. It is also called a Form A contact or "make" contact. NO contacts may also be distinguished as "early-make" or NOEM, which means that the contacts close before the button or switch is fully engaged.
Normally-closed (NC) contacts disconnect the circuit when the relay is activated; the circuit is connected when the relay is inactive. It is also called a Form B contact or "break" contact. NC contacts may also be distinguished as "late-break" or NCLB, which means that the contacts stay closed until the button or switch is fully disengaged.
   
Learning method and steps:
1 Press the learning button and LED on the receiver will light up, enter the learning state.
 
2 Press the key you want to learn on remote control within 2-5 seconds , LED flash 3 times and then turn off , then it have success in learning .
 
  
Clear the deposit information
Keep Pressing Learning Key , LED turns on , Wait 8-10 Seconds , LED turn off , that deposited information has been successfully cleared ;
 
Work mode (programmable ):
singnal Non-locking (Momentary    is defult )
singnal Self-locking (Toggle  )
singnal Inter-locking (Latch)
Work Mode can be adjustable by jumper,Please operation under power off
 
Work mode explanation:
Momentary------------Press the Transmitter button A, the receiver relay A is ON, release button A; the receiver relay A is OFF, the same as B/C/D ,Every channel is Independent ;
 
Toggle---------------Press transmitter button A for 1 time , the receiver relay A is ON, press button A again, the receiver relay A is OFF, the same as B/C/D. Every channel is Independent ;
  
Latched------------------
Press transmitter button A, the receiver relay A is ON, the relay B/C/D is OFF.
Press transmitter button B, the receiver relay B is ON, the relay A/C/D is OFF.
Press transmitter button C, the receiver relay C is ON, the relay A/B/D is OFF
Press transmitter button D, the receiver relay D is ON, the relay A/B/C is OFF.