A cím elején, valamint az első képen szereplő szín/minta/méret/típus kerül kiszállításra!
DC 5V 12V 8ch Modbus Rtu UART TTL232 IO vezérlőmodul az Arduino UNO MEGA relé PLC kenyértáblához
DC 5V 12V 8ch Modbus Rtu UART TTL232 IO Control Module for Arduino UNO MEGA Relay PLC Breadboard
 
 
Product Name: DC 5V 12V 8ch Modbus Rtu UART TTL232 IO Control Module for Arduiuo UNO MEGA Relay PLC Breadboard
 
 
Package inlcuded:
1 x 5V/12V 8 Channel Multifunction RS232(TTL Lever) Control Board for 1-8 CH Relay Module
 
Description:
 
1 Working voltage: DC 5V (5V version) / DC 6-24V (12V version)
 
2 Working current: 8-13MA
 
3 Two command control modes: AT command and MODBUS command
 
4 The maximum delay under the AT command is 9999 seconds, and the maximum delay under the MODBUS command is 255 seconds
 
5 AT commands can be input by the serial port super terminal (serial assistant);
MODBUS commands can also be input by ''Modbus Poll'' in addition to the serial port super terminal input
 
6 RS232 (TTL level) input interface(2.54MM Pin)
 
7 8 output control pins(2.54MM Pin), 5V TTL level, low level (default)/high level output
 
8 Four versions: 12V with needle/12V without needle/5V with needle/5V without needle
 
9 Size: 30*25.4*2MM
10 Weight: 4.5g with Pin, 3.5g no Pin
 
 
 
Instruction manual Please ask us after the purchase
 
 
Application
Automated industry PLC
UNO MEGA Relay Module
Smart Home,Home Automation ;
Identification system;
Motor FW & BW;
CCTV Camera PTZ Control;
Security system;
LED dot matrix screen;
RS232 RS485 remote control;
 
Command mode selection :( figure above) M0 disconnect is MODBUS command mode. M0 Connect is AT command mode.
Output level selection : ( figure above) M1 disconnect is Low level output. M1 Connect is Hight level output
Slave ID: Different ''Sliver ID'' can be set by command, the maximum number is 247
Under the MODBUS command mode,the slave ID must be correct
command Description, Please refer to '' TL19A08 8-channel TTL output module commamd''
 
Typical applications:
 
1 AT command mode (M0 Connect), in this mode can be through the serial HyperTerminal (serial assistant) enter a simple AT command control relay. AT command mode time up to 9999 seconds
 
 
2 MODBUS command mode (M0 disconnect), you can control a variety of ways: Serial Hyper Terminal Control (need to manually add the CRC), Modbus Poll software control (software automatically add the CRC), PLC or MCU process control
 
 
It can control 1-8 channels 5V/6V/9V/12V/24V Relay Module
With RS485 interface and RS232 (TTL) interface
12V 5V version relay wiring diagram
Test Software(We offer a demo video):
Serial HyperTerminal:
Modbus Poll
 
 
 
 
 
1005002666932870/1 - shop1525466