ADXL345 3 tengelyes digitális gravitációs érzékelő I2C gyorsulásmérő modul dőlésérzékelő háromtengelyes gyorsulásmérő kitörési tábla Arduinohoz
ADXL345 3-Axis Digital Gravity Sensor I2C Accelerometer Module Tilt Sensor Triple Axis Accelerometer Breakout Board For Arduino
Description
The ADXL345 is a small, thin, low power, 3-axis MEMS accelerometer with high resolution (13-bit) measurement at up to /-16 g. Digital output data is formatted as 16-bit twos complement and is accessible through either a SPI (3- or 4-wire) or I2C digital interface.
The ADXL345 is well suited to measure the static acceleration of gravity in tilt-sensing applications, as well as dynamic acceleration resulting from motion or shock. Its high resolution (4 mg/LSB) enables measurement of inclination changes less than 1.0 degrees.
You can solder it onto experiment PCB or your own design PCB easily  with the help of the SMD pins.
Features:
- Compatibility: Because the logic level is 3.3V 5V compatible, it is compatible for Arduino.
- Module type: 3-Axis Accelerometer
- Interface: I2C
- Operating voltage: 3.2 – 5.5V
- Logic level: 5V or 3.3V (onboard 3.3V level converter circuit)
- Ultra Low Power: about 0.1mA in measurement mode, 0.2uA in standby@ 3.3V
- IO Port Package: Both SMD and PAD are available, and the pin pitch is 2.54mm.
- Application: HDD shock protection, Vibration sensor, Game controller input, Robotics, Smart vehicles.
Photos
 
 
Part List (Schematics and program can be sent via e-mail,Please contact us)
 
1 x module
 
               
Please Note That (Note: After you buy the product, the documents can be send, Please contact us)
32913586782 - opensmart