- -40%
DC motor meghajtó kártya 2 utas motoros meghajtó modul DRV8833 motoros meghajtó modul kis méretű
DC motor meghajtó kártya 2 utas motoros meghajtó modul DRV8833 motoros meghajtó modul kis méretű
116 Ft
40% megtakarítás
194 Ft
Nincs adó
Parameter:
Size: 18.5*16 mm
Input voltage: 3——10V
Single H-bridge output current: 1.5A, which can drive 2 DC geared motors.
Built-in overcurrent protection, short circuit protection, undervoltage lockout and overheating protection. With low power consumption, sleep mode.
Purpose: It can drive DC motors below 1.5A and 4-wire stepper motors.
Instructions for use:
ULT low level is sleep mode (need to disconnect the J2 short solder joint behind the module)
OUT1, UT2 are 1 H bridge, and the corresponding control is IN1, IN2.
OUT3, 0UT4 are the second H bridge, and the corresponding control is IN3, IN4.
EEP is a protection output and is not used by default.
VCC is the voltage input 3 to 10V.
GND is grounded.
Size: 18.5*16 mm
Input voltage: 3——10V
Single H-bridge output current: 1.5A, which can drive 2 DC geared motors.
Built-in overcurrent protection, short circuit protection, undervoltage lockout and overheating protection. With low power consumption, sleep mode.
Purpose: It can drive DC motors below 1.5A and 4-wire stepper motors.
Instructions for use:
ULT low level is sleep mode (need to disconnect the J2 short solder joint behind the module)
OUT1, UT2 are 1 H bridge, and the corresponding control is IN1, IN2.
OUT3, 0UT4 are the second H bridge, and the corresponding control is IN3, IN4.
EEP is a protection output and is not used by default.
VCC is the voltage input 3 to 10V.
GND is grounded.
Biztonsági feltételek
Szállításii feltételek
Visszaküldési feltételek
