- -43%
4S 40A Li-ion Li-ion Akkumulátor 18650 Töltő PCB BMS Védőtábla fúrómotorhoz 14,8V 16,8V Lipo Cell
4S 40A Li-ion Li-ion Akkumulátor 18650 Töltő PCB BMS Védőtábla fúrómotorhoz 14,8V 16,8V Lipo Cell
218 Ft
43% megtakarítás
383 Ft
Nincs adó
Scope of application: suitable for lithium batteries with a nominal voltage of 3.7V and a full voltage of 4.2V
(Including 18650, 26650, polymer lithium batteries, there is no size limit)
Product size: 45*60*3.4mm (balanced version)
Charging voltage: 16.8V~18.1V
Continuous discharge current (upper limit): 40A (if the heat dissipation environment is not good, please reduce the load current to use) Continuous charging current (upper limit): 20A
It is suitable for electric drills with starting current below 80A and power below 230W, with balanced charging function.
Note 1: 4 10C-20C power batteries, or 8 5C-10C power batteries are required to start the electric drill successfully (recommended power battery models: SONYVTC4, VTC4A, VTC5A, VTC6)
For 0V and 12.6V connection lines, use copper wires of more than 3 square millimeters (nickel sheets cannot be used!!!).
Note 2: Strictly connect 0V, 4.2V, 84V, 12.6V, 16.8V according to the diagram.
Can touch any component on the board, do not intentionally short circuit.
Note 3: When soldering the battery for the first time or charging, as long as a single battery exceeds 4.2V
The "430" resistor will heat up and discharge (discharge to about 4.19V and stop heating). If the 430" resistor is seriously hot (don't dare to touch it when it is too hot), please check whether the wrong wire is connected.
(Including 18650, 26650, polymer lithium batteries, there is no size limit)
Product size: 45*60*3.4mm (balanced version)
Charging voltage: 16.8V~18.1V
Continuous discharge current (upper limit): 40A (if the heat dissipation environment is not good, please reduce the load current to use) Continuous charging current (upper limit): 20A
It is suitable for electric drills with starting current below 80A and power below 230W, with balanced charging function.
Note 1: 4 10C-20C power batteries, or 8 5C-10C power batteries are required to start the electric drill successfully (recommended power battery models: SONYVTC4, VTC4A, VTC5A, VTC6)
For 0V and 12.6V connection lines, use copper wires of more than 3 square millimeters (nickel sheets cannot be used!!!).
Note 2: Strictly connect 0V, 4.2V, 84V, 12.6V, 16.8V according to the diagram.
Can touch any component on the board, do not intentionally short circuit.
Note 3: When soldering the battery for the first time or charging, as long as a single battery exceeds 4.2V
The "430" resistor will heat up and discharge (discharge to about 4.19V and stop heating). If the 430" resistor is seriously hot (don't dare to touch it when it is too hot), please check whether the wrong wire is connected.
Biztonsági feltételek
Szállításii feltételek
Visszaküldési feltételek
