1db HM-10 átlátszó soros portos Bluetooth 4.0 modul logikai szintű fordítóval
1pc HM-10 transparent serial port Bluetooth 4.0 module with logic level translator
Product update in 2013, Bluetooth 4.0 module. BT V4 module interface and MCU connection only need 4 wires: 5V (VCC) GND TXD RXD
Advantages of this module:
1. With logic level conversion circuit inside. No need to externally convert 5V level to 3.3V level
2. The power input port is equipped with anti-reverse circuit. Avoid accidental power plugging, which may cause the module to burn out.
 
Support Apple IOS5 /IOS6 system, please download the following materials before purchasing. Thank you!
 
HM-10 module data package download: (Already include IOS5/6 development source code, module AT commands, etc., please download by yourself, thank you!)
hm-10 tutorial:
Several important points of IOS, I hope customers will read this document before using the module! learn by heart.
(Applicable to Apple machines after 4s 5 5s)
Use on IOS:
1. IOS search for Bluetooth, not search and pair Bluetooth in Settings-"Bluetooth. (Only Bluetooth headsets can be connected in IOS settings. Wireless data devices cannot be found)
2. In IOS, search for the LightBlue software in the appstore, and then open the LightBlue software to search for HM-10, and pair and test sending and receiving!
---------------------------------------------
Android phone
1. First confirm whether the Bluetooth module of the Android phone hardware supports Bluetooth 4.0. (If the phone hardware module does not support it, the software will not be connected if it is done correctly!)
2. Upgrade the system to version 4.3 or later
3. The HMBLEComAssistant.rar in the data package can be used to test sending and receiving
------------------------------------------------
PS: Develop the mobile terminal of IOS or Android. Please visit http://www.jnhuamao.cn/download.asp?ID=0 to download the new source code for reference!
--------------HM-10 module configuration requires a USB to TTL device. No wireless pairing can be configured! (Because after wireless pairing, the data is directly transmitted transparently) ----------
1. The LED flashes slowly when it is not paired and connected with the remote device. At this time, you can use AT commands to configure the module.
2. The HM-10 module can only recognize all uppercase AT commands, and does not support lowercase and mixed case.
3. The factory default baud rate is 9600 8n1
Slave settings
AT BAUD0 //9600 will take effect after power off and restart
AT NAMEAC
AT PASS000000 //You must enter full 6 digits
AT TYPE1
AT ROLE0
 
Host settings:
AT BAUD0 //9600 will take effect after power off and restart
AT NAMEAC
AT PASS000000 //You must enter full 6 digits
AT TYPE1
AT ROLE1
Weight: 3.2g
Size: 46*17*5mm
 
 
 
 
 
4.2/0.95
1005003280168927 - a a