- -44%
Nincs szín - EIM PLUS 630-465 12V DC motor interfész modul indítómotor mágnesszelep izzítógyertya
Nincs szín - EIM PLUS 630-465 12V DC motor interfész modul indítómotor mágnesszelep izzítógyertya
3 406 Ft
44% megtakarítás
6 082 Ft
Nincs adó
EIM PLUS 630-465 12V DC Engine Interface Module Starter Motor Solenoid Glow Plug
Features:
* 100% Brand New And High Quality
* Made Of High-quality Materials, Durable
* The Engine Interface Module Is Sealed. The Module Installed In The Engine Provides Switch Relays For The Starter Motor Solenoid Valve, Glow Plug And Fuel Solenoid Valve.
* Each Of These Circuits Is Protected By A Separate Fuse Installed In The Module. When Each Circuit Is Energized, A Single Led Lights Up.
* There Are Two Versions Of The Engine Interface Module: Eim Basic Version: Elm Works With A Control Panel Equipped With An Overspeed Shutdown Function.
* Eim Plus: Elim Plus Is Used In Conjunction With A Control Panel That Is Not Equipped With An Over-speed Shutdown Function.
Overspeed Signal (eim Plus Only) Elm Plus Monitors The Speed Signal From The Electromagnetic Sensor.
*if The Engine Speed Rises Above A Certain Preset Value, The Module Will Send A Zero Volt Signal To The Generator Set Control Panel To Activate The Overspeed Fault Circuit.
*for The 50 Hz Group, The Overspeed Set Point Is Factory Set To 55 Hz, And For The 60 Hz Group, The Overspeed Set Point Is Factory Set To 66 Hz.
*it Can Be Adjusted Using The Adjustment Screw In The Hole Next To The Led Via The Overspeed Setting.
*when The Engine Is Running At Rated Speed (1500 Rpm At 50 Hz Or 1800 Rpm At 60 Hz), The Adjustment Screw Should Be Adjusted Until The "overspeed Setting" Indicator Light Goes Out.
This Will Set The Overspeed Value 10% Higher Than The Operating Speed Of The Generator Set.
Specifications:
* Number: 630-645
* Voltage: 12V DC
* Model: EIM PLUS
Package Contents:
1 * Engine Interface Module
Note:
1.The real color of the item may be slightly different from the pictures shown on website caused by many factors such as brightness of your monitor and light brightness.
2.Please allow slight manual measurement deviation for the data.
Features:
* 100% Brand New And High Quality
* Made Of High-quality Materials, Durable
* The Engine Interface Module Is Sealed. The Module Installed In The Engine Provides Switch Relays For The Starter Motor Solenoid Valve, Glow Plug And Fuel Solenoid Valve.
* Each Of These Circuits Is Protected By A Separate Fuse Installed In The Module. When Each Circuit Is Energized, A Single Led Lights Up.
* There Are Two Versions Of The Engine Interface Module: Eim Basic Version: Elm Works With A Control Panel Equipped With An Overspeed Shutdown Function.
* Eim Plus: Elim Plus Is Used In Conjunction With A Control Panel That Is Not Equipped With An Over-speed Shutdown Function.
Overspeed Signal (eim Plus Only) Elm Plus Monitors The Speed Signal From The Electromagnetic Sensor.
*if The Engine Speed Rises Above A Certain Preset Value, The Module Will Send A Zero Volt Signal To The Generator Set Control Panel To Activate The Overspeed Fault Circuit.
*for The 50 Hz Group, The Overspeed Set Point Is Factory Set To 55 Hz, And For The 60 Hz Group, The Overspeed Set Point Is Factory Set To 66 Hz.
*it Can Be Adjusted Using The Adjustment Screw In The Hole Next To The Led Via The Overspeed Setting.
*when The Engine Is Running At Rated Speed (1500 Rpm At 50 Hz Or 1800 Rpm At 60 Hz), The Adjustment Screw Should Be Adjusted Until The "overspeed Setting" Indicator Light Goes Out.
This Will Set The Overspeed Value 10% Higher Than The Operating Speed Of The Generator Set.
Specifications:
* Number: 630-645
* Voltage: 12V DC
* Model: EIM PLUS
Package Contents:
1 * Engine Interface Module
Note:
1.The real color of the item may be slightly different from the pictures shown on website caused by many factors such as brightness of your monitor and light brightness.
2.Please allow slight manual measurement deviation for the data.
Biztonsági feltételek
Szállításii feltételek
Visszaküldési feltételek