A cím elején, valamint az első képen szereplő szín/minta/méret/típus kerül kiszállításra!
ENC28J60 SPI interfész hálózati modul Ethernet modul (mini verzió) az arduino 51LPC AVR ARM PIC számára
ENC28J60 SPI Interface Network Module Ethernet Module (Mini Version) for arduino 51LPC AVR ARM PIC
ENC28J60 LAN
Brand new and high quality.
chip board ENC28J60-I/SO.
the board 25MHZ crystal.
the network interface board HR911105A.
3.3 V power supply pin.
Size:5.9cm x 3.5cm - 2.32inch x 1.38inch.
Debug reminder:
1, the IP address of the computer to a network segment and module such as IP module 192.168.1.2, IP computer set: 192.168.1.3; 192.168.1 is the 3 section;
2, cross the network cable connected to the mouth of the computer network module and mouth; (that is, the cable network 1 3,2 cross, and then do not understand that there are pictures Baidu);
3, the module and the MCU connection should pay attention to the connection of each line is reliable (the surface is not even connected to the good);
4, and the MCU port IO to confirm that is right;
5, the program recompile, download, confirm whether to download! STM32 and 51 IO
Wiring instructions:
############STM32 connection ##########
STM32f103VBT6 ENC28J60 module or other stm32
PC10----------- RESET
PC12--------- CS //PC12 pull-up output mode
//SPI1-
PA5----------- SCK / / output mode
PA6----------- SO / / input mode
PA7----------- SI / / output mode
######51 microcontroller ########### //---------------------------------
Change IP address and MAC address in uipopt.h
192.168.1.100
//--------------------------------- port configuration in spi.h.
STC12C5A60S2 DIP OSC:18.432Msbit CSN = P1^0; / / 28J60-- CS (SS)
Sbit SIN = P1^1; / / MOSI
Sbit SON = P1^2; / / MISO
Sbit SCKN = P1^3; / / SCK
Sbit RSTN = P1^4; / / RST
Sbit INTN = P3^3; / / INT
ENC28J60 Mini
1. Chip board ENC28J60/SS.
2. The board 25MHZ crystal.
3. The network interface board HR911105A.
4. 3.3V power supply pin.
5. Size: 48.8 (mm) x 18.5 (mm).
1005003662792232/2 - pngto