DC 5V 433mHz 2 csatornás vezeték nélküli késleltető relé távirányító

Work mode
   
 
 
Typical applications:
DC 5V Home lighting system 
Garage Door
Elevators
Motor reversing control
Remote control switch
Smart Home / Home Automation
LED lighting
Fluorescent lamp
DC 5 DC Motor,RS360
 
 
Wiring Diagram 1:
DC 5V control circuit,Wiring diagram below. "LOAD" may be LED lights, fans, motors and other DC 5V
 
 
 
 
Wiring Diagram 2:
DC 1-48V OR AC 85-265V control circuit,Wiring diagram below(Note:If not DC 5V load, need another DC 5V power supply). "LOAD" may be LED lights, fans, motors and other DC AC equipment
 
  
Product Name : DC 5V 433mHz 2 Channel Wireless Delay Relay Remote Controller 
 
Packing list:
1 PCS 433M DC 5V 2 Channel Multifunction Wireless Controller 
2 PCS  433M    2 Button EV1527  Remote Control (USE 12V 27A battery,Batteries not included)
 
 
 
Technical indicators:
Operating voltage : DC 5V 
Operating Current : All relays close,about 15MA; one relay open,about 86MA;two relay  open,about 157MA
Operating frequency : 433.92M; 
Receiver sensitivity  : -108dB;
Work mode       : Non-locking (Momentary is defult),Self-locking (Toggle),Inter-locking (Latch),  Delay;Each channel independently set the Work mode; 500,000 seconds maximum delay
 
Size(Including housing)  : 75*54*28mm
Learning function (can works with EV1527 and PT2262 remote, can store 16 pcs different code remote );
Max load : 500W;
  
Normally, we would adapter remote control and receiver.
If the item you received has not been adapted Or you need to add accessories, Please follow the instructions below
Learning method and steps:
Under normal operating mode, LED will be lit, when receives a valid remote control (EV1527 / PT2262) button values, LED flashes
   
Clean code: press the button and held down, LED off, LED will light about 8 seconds later, clean code is completed (Note: After performing clean code previously stored remote control value does not exist)
     
Step 1 (into the learning mode): Press the button (about 1 second), LED off;
Step 2 (adapter channel 1): Then press the first button on the remote control, LED flashes four times off, then learning the first button value
Step 3 (Adaptation Channel 2): Then press the second button on the remote control, LED flashes four times brighter, then learned two key values
 
Use more details, please click here!
 
 
 
433M 2 Button EV1527 Remote Control:
 
Power supply : 12V 27A battery  replacable .(This remote doesnot have a battery , Please buy in your local market )
Operating current:  ≤ 12mA ;
Oscillation mode:  SAW resonator ;
Oscillation resistor : 330K
Modulation mode: ASK OOK ;
Operating frequency: 433.92MHz  ;
Frequency dev iation: ±0.2MHz ;
Encoding format: Million  Group Code (  EV1527 ) ;
Transmit power: 10 mW.
Data Rate : 50~60KHZ;