10x 3V 3.3V 3.7V 4.2V – 5V dc-dc fokozó boost konverter 18650 power bankhoz 3D nyomtató banana pi LED OLED LCD
10x 3V 3.3V 3.7V 4.2V to 5V dc-dc step up boost converter for 18650 power bank 3d printer banana pi LED OLED LCD
Product Name : 10x 3V 3.3V 3.7V 4.2V to 5V dc-dc step up boost converter for 18650 3d printer power bank banana pi LED OLED LCD
 
  Packing list:
10 PCS 5W 3V 3.3V 3.7V 4.5V TO 5V  Boost Step-UP Voltage Regulator    Module

 
 
Description: 
 
Input voltage 2.6~6V, output 5V (deviation -6% )
 
Maximum input current :  1.2A
Long-term work Current : 1A
Conversion efficiency : 79-91%
  
Start Voltage 2.6V, Output Current 51MA
 
INPUT 2.8V 1A;  OUTPUT  5V 291MA
INPUT 3V 1A;    OUTPUT  5V 480MA
INPUT 3.3V 1A;  OUTPUT  5V 592MA
INPUT 3.7V 1A;  OUTPUT  5V 650MA
INPUT 4.5V 1A;  OUTPUT  5V 791MA
 
DC-DC Boost module working frequency 1.0MHZ. 
Operating ambient temperature : -40~ 85 Degrees Celsius
2.54mm pin pitch,Arduiuo UNO DUE Breadboard FPGA/CPLD   Development Board friendly.
Over Temperature Protection
Over Voltage Protection
Excluding Pin Size 20.5mm x 10.16mm x 5.6mm(Very small)
Weight : about 1.4g(Very light)
 
Applications:
MCU Development Board,FPGA/CPLD UNO MEGA2560 DUE 8051 AVR C8051 etc
raspberry pi 1/2/3,breadboard
18650 lithium battery power bank
3d printer
banana pi
MP3 MP3 mobile phone charger
5V Relay board
5V LED OLED LCD
Wireless communication equipment
315M 433M Wireless remote controller
 
Attention :
 
This is a DC-DC voltage converter module,Must be noted when using:
1 Input voltage can not be greater than the maximum input range
2 Output power can not be greater than the maximum load for a long time
3 Input power must be greater than the output power, because the power consumption of the module itself
 
Q & A:
Q : Why output voltage is less than the nominal voltage
A : Input power supply power is too low.Test the input voltage with a multimeter, a t this time of the input voltage is very low
32650448564 - shop1525466